Protect Your Windows – Board Up!!
|
|
Posted On :
Sep-05-2011
| seen (896) times |
Article Word Count :
466
|
|
A hurricane is a tropical hundred and fifty miles per hour storm that accompanied by pouring rains, violent, dashing waves, and whistling winds. A hurricane can possibly produce tornadoes.
|
|
A hurricane is a tropical hundred and fifty miles per hour storm that accompanied by pouring rains, violent, dashing waves, and whistling winds. A hurricane can possibly produce tornadoes. It is vital that to properly prepare your home for a hurricane so you and your family can safe at such situations. The best thing you can do is to board up the windows of your home.
The next best option, then, in preparation for an unexpected disaster, is to timber up the windows in your house with wood. The wood not only helps to defend your Kansas City windows from airborne wreckage, but it also helps to resist the force of the bad blowing winds.
Using wood work is far better than using tape. There is an existing practice of applying duct tape or another type of tough tape across the glass in the windows. The purpose is to keep the glass from shattering into a room if the windows break. However, tape is not defiant to the violent force of a typhoon.
The first step to start up your windows is to measure all of the windows in your house. Mark the dimensions, and take them to your lumber yard or home improvement store. With the measurements, the salesmen can help you settle on how much wood you'll require
You'll need to buy more than a few sheets of marine plywood that are at least five eighths of an inch thick. This breadth should provide enough shielding for your windows replacement Kansas City glass. Then, use a measuring tape and a marker to measure and mark the pieces of plywood that you'll need. But, in order for the wood to fit properly into the window frames, you'll need to make the wood pieces a bit smaller. That is, you'll have to to remove about an eighth of an inch off the width and height of each window.
While using an electric saw to cut out each piece of wood, be sure that you use the markings to identify each piece like, "South Bed Room Window", "Bathroom Window", "North Master Bedroom Window", etc.
Once all cut pieces are at hand, you'll require having a helper hold them in place, one by one, on their corresponding windows. The next thing to do is to use an electric drill to make holes through the wood and each window frame. These holes are to be just about 12 inches apart, encompassing the complete diameter of each window.
To end with, you will need several metal or wooden fasteners that gauge approximately an inch long, to secure the pieces of wood to your windows. Place the cut pieces and the screws stored in a safe place.
|
|
|
|
Article Source :
http://www.articleseen.com/Article_Protect Your Windows – Board Up!!_79826.aspx
|
|
Author Resource :
The author of this article has been writing many good articles related to home improvement. A lot of expertise is shared through resourceful blogs and articles written on Kansas City Windows and Kansas City Doors fixing such as Window Manufacturing methods, DIY for Window fixing, Windows replacement Kansas City, etc.
|
|
Keywords :
Kansas City Windows, Kansas City Doors, Windows replacement Kansas City, windows,
Category :
Home and Family
:
Home Improvement
|
|
|
|
