|
|
Facts About Washing Machine Technology
|
|
Posted On :
Dec-03-2011
| seen (700) times |
Article Word Count :
467
|
|
The first practical machine was patented in 1858 by Hamilton Smith. Later, William Blackstone built as a gift for his wife by a handle and a gear to.
|
|
The electric washing machines started at the beginning of the twentieth century surface. Until 1910, the mass units of companies such as Maytag and Hurley Machine Corporation produced.
The first machines were heavy and dirty pans made of cast iron. A mechanism has been put in a tub mounted on angle iron frame. There was perforated or slatted cylinders inside. The unprotected motor was placed under the machine and dripping water, it often causes a short circuit. In the 1920s, had the Canadian machines installed gas or electric heaters, but if most of the houses had begun in the 1930s by the domestic water heaters, heating was useless machines. Later there was the inclusion of a timing device in the machine and allows the unit to a predetermined washing cycle can be adjusted. The early 1950s brought machines with rotating capabilities, which replaces the deficiency, as it cared to remove buttons. Finally, in 1957, GE was using a machine with five buttons to control the wash temperature, wash temperature and spin speed. All these additives eliminates the need for constant monitoring. While some improvements have since been made in the washing machines in order to operate more efficiently and more conveniently, the basic structure has not undergone any significant change.
One of the biggest problems with these washers is the fact that they have a lot of water and energy consumption. Since both commodities are scarce quickly, there is the need for time to come up with a machinethat uses as little as possible these two things. A new machine developed by researchers at the University of Leeds uses only 2% of the water used by conventional machines.
These new devices use some basic chemistry as a major operation. The machine uses nylon beads are positively charged and thus set the stains with ease. The structure of the beads so that compliance with the beads to spot and home to acts as a catalyst for the washing powder. They act to increase the specificity of the detergent on the tough spots.
The operation of the device is relatively simple. All that needs to be done is to load the machine with clothes, and let the balls with the dirty clothes mixed. Then add about a cup of water and detergent as in a conventional machine, and you can start the washing process. At the end of the wash, drains the water and the beads are filtered off.
Some of the benefits include a minimal amount of water and energy consumption. The method is suitable for dry cleaning, as well as conventional washing. The beads can be up to 100 times so that they can be commercially exploited. The laundry is environmentally friendly and does not harm clothing.
|
|
|
|
Article Source :
http://www.articleseen.com/Article_Facts About Washing Machine Technology_113889.aspx
|
|
Author Resource :
You may also be interested in washer-dryer.
|
|
Keywords :
washing, mashine,
Category :
Product Reviews
:
Consumer Electronics
|
|
|
|
|
|
